This is a must have in your flex-shaft accessories. Snip two inches long by 3/4 inch wide of Wet n Dry sandpaper. The Sandpaper or split mandrel has a "split" above the reinforced base allowing the user to wind sandpaper, polishing cloth, or other abrasives around the gap. Hold the grit facing you, load it in the mandrel and curl the sandpaper around the mandrel.

This handy tool will sand off burs on your metal, or inside a ring. It can soften the edge of a band ring or remove scratches. This mandrel comes in straight and tapered styles and is generally used to sand in tight spots. The Sandpaper or split mandrel has a "split" above the reinforced base allowing the user to wind sandpaper, polishing cloth, or other abrasives around the gap. This mandrel comes in straight and tapered styles and is generally used to sand in tight spots.

The straight version is good for finishing smooth surfaces while the tapered offers access to undercuts. Maximum and recommended speeds depend on the type and size of accessory, as well as the mandrel in use. The ratings we publish for our mandrels are based on an 1" overhang with an accessory that weighs under 1 gram, and is smaller than 1/2" in diameter. As a general rule, smaller accessories and mandrels can be used at higher speeds than larger accessories and mandrels. It is a good idea to follow the recommendations that come with both the accessory and the mandrel you are using.

See handy Tips, Tricks and Advice on the Flex-shaft